Aquamist DDS3 V.10 Install Pics

[daisaw1219]

any more info on the power box. I always wanted to make a box where i can tap power from for all my gauges and wideband becasue i am tired of splicing into different wires. It seems like a good idea, ive actually seen a fuse block type setup which was selling at summit for $150 which is similar but i dont think its worth it.

[dudical26]

This power box cost me about $5 to build....so way less than the $150 summit wants.

It does not have a fuse in the power box itself but there is a fuse just before the power goes into the box. If you wanted you could get one of these fuses

http://www.jtekmachinery.com/p-5468-daito-hp32.aspx

And a solder on fuse holder for circuit boards. Then you could have the fuse inside the box if you really wanted.

Here are the screw terminals

http://www.winford.com/products/stb.php

All you do is just lay down a big bead of solder along each side of the board which ties all the pins on the screw down terminals together. 1 side for ground and one for power. Then just tap power and ground somewhere and supply to the top of each "rail"

[Slick-IX]

oh man ive been off the meth section for a while... i didnt even know v10 was out lol

looking good dub, i got my flow sensor on the same spot