Mark this thread as Unsold
xtss, megan o2, throttle body + sensors, wing
Mar 12, 2012, 07:11 AM
#1
Evolving Member
Thread Starter
iTrader: (3)
Join Date: Apr 2011
Location: MO
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
xtss, megan o2, throttle body + sensors, wing
For sale... xtss with oem flywheel. Only has 7k miles on it but honestly looks a lot more rough than that. pulled it out for an exedy twin. didn't slip on my red setup at 488hp but in all honesty did lock me out @ over 6500. I would think it would make a good clutch for someone looking to just cruise and a stockish setup that isn't trying high rpm shifts.
ACT xtss with stock flywheel
75 shipped!!
Plastic 8 BOV $10 + shipping
Also selling a qm v1. unknown mileage, was running good when pulled out of car until the TOB seal blew. the seal was replaced! only needs a flywheel. And i do know the date is old on the pic.
$125 shipped.
ACT xtss with stock flywheel
75 shipped!!
Plastic 8 BOV $10 + shipping
Also selling a qm v1. unknown mileage, was running good when pulled out of car until the TOB seal blew. the seal was replaced! only needs a flywheel. And i do know the date is old on the pic.
$125 shipped.
Last edited by jonzie04; Apr 24, 2012 at 09:55 PM.
Trending Topics
Apr 25, 2012, 05:30 AM
#10
Evolving Member
Thread Starter
iTrader: (3)
Join Date: Apr 2011
Location: MO
Posts: 187
Likes: 0
Received 0 Likes
on
0 Posts
the car has nearly 120k on it, so i would guess the flywheel to have that much on it. I would say it can for sure be resurfaced but cannot confirm it. is there anyway to tell?
Apr 25, 2012, 01:19 PM
#12
Evolving Member
iTrader: (12)
Join Date: Jun 2008
Location: San Diego, California
Posts: 202
Likes: 0
Received 0 Likes
on
0 Posts
Not sure if you can measure flywheel thickness like you can measure rotor thicknesses but I would assume that is the way you would be able to tell if you can resurface it or not.