tephra

Offline

Hello. Mail was the first time.
My car is "2008 JDM Mitsubishi EVOX SST"
EVOSCAN MODE23 address is unknown, so please tell us in writing.
My definition file "SM5237" is.
Thank you.

Hi Tephra, I need your help with the advanced fuel control patches for the 88580014 rom...

Hi Tephra

A few day ago i try modify my ADM mivec table using JDM table to write to the ecu via open port 2. Half way through writing suddenly the interface closed for no reason, after that i'm unable to read or write to the ecu. I've try a few methods posted on this forum without success. This morning i unplug ecu's plug somehow when i turn the ignition to on position the radiator fan switch on is this normal for the fan start without the ecu plug in.

Please help

Hey. Can U send me Your email adress? This is very important

i would like to appreciate your help and wud like to make a donation. Let me know whats the paypal id. Thanks!

Hey was i able to help you with the iEGR thing or did i make things worse?

Hello, I am trying to mail you for DTC disable on rom id 53050009 for the evo x MR Edm. Guess I have the email id wrong.

There is nothing on the forums for this. Please PM if possible.

Thanks!

whats up? do you have a msn or aim account? wanted to chat about some stuff. mine is

MSN-evo_kid@comcast.net
AIM-jaymarkus001

or Pm me

Jay

Hi, I hear your the person to ask about Methanol Injection. Im getting installed: FP RED, 1000cc injectors, ams fuel rail kit, walbro 255. Already have basic bolt ons, Shep tranny, stock motor, stock boost solenoid, stock BOV, and ECUtek tune(___tuned)337whp 331wtq 26psi. My problem is: Im in doubt on Meth injection. My tuner is reccomending HFS-1 Aquamist 100% methanol. I want to know your take on this set-up as I am worried about blowing my motor and the fail safes.

What do you recommend and what can I do to make running meth as safe as possible, and what is your take on 50/50 as to 100% meth. Also what is your take on AEM's Water meth kit? Thanks.

Hello Tephra. Thank you very much for all your contributions to the open source software and evoscan for all the guys here. I ran into a small problem and want to see if you had any ideas. I had ecuflash 1.41 first release for a while now. That was why the ECU id wasn't showing the full number. So I downloaded the 1.42 version and got the id number. My maps no longer show under it. Not sure why but most bothersome is that when i pull the rom from the ecu using 1.42 it gives me checksum error every time after it is finished. I obviously do not want to brick my ecu, any ideas on why I am getting this error? Is it due to the map having been altered using 1.41? Can I enable mode 23 with my old 1.41 version and just avoid using 1.42? thanks for any help!