EvolutionM - Mitsubishi Lancer and Lancer Evolution Community

Notices

Jersey Dino Jersey Dino is offline

Evolved Member

Last Activity: Sep 7, 2023 06:15 PM

About Me

  • About Jersey Dino
    Location
    North Jersey
    Vehicle
    2006 GG EVO IX, NA6(8)C Miata, 2014 Audi Q5 2.0, 2006 Triumph Speed Triple
    Gender
    Male
  • Signature
    06 Graphite Grey EVO IX. Speed Density Setup
    ETS intake/ETS UICP short route/ETS V2 LICP/ TTP 02 Housing/Turbo XS TBE(race pipe)/Grimspeed EBC/Tial Q/FIC High Impedance 1100/Walbro 255/HTA Green with FAP/ETS 3.5in FMIC/GSC S1 Cams/Running 50:50 Meth/Defi Link II & BF series boost gauge/
    ROBISPEC///
    TEIN Flex with Pillow Mounts & EDFC/Rear Trailing Arm Bushings/Rear Bump Steer Kit/Front Roll Center Kit/Rear Sway Bar
    Enkei NT03 18x9.5
    Ferrodo DS2500 pads/DBA5000/DBA4000/Stainless lines
    QM 8 Leg Race Clutch Setup with Hydraulic Release Bearing.

Statistics

Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: Sep 7, 2023 06:15 PM
  • Join Date: Apr 11, 2006

Friends

Showing Friends 1 to 2 of 2

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. Jersey Dino
    Jan 9, 2009 10:03 AM
    ben,
    unfortunately its not for sale yet. I might be able to fab one up for you, but they do take a while to make and finish up. My downpipe actually had a bung welded on from the factory but any mufler shop should be able to do it. just have them mark it out and make sure the sensor is between 12 and 3 o'clock or 9 and 12 o'clock. Other wise the sensor will be prone to failure due to condensation on a hot sensor. are you going to wire the wideband upyour self or do you need me to do it? If its anything like the LC1, then its a bit involoved.
  2. benniboi08
    Jan 6, 2009 12:39 PM
    Hey Dino,
    Whats up! Hope all is well with you and your car+meth but I am in the market for an AEM wideband as recommended by Tamer before my tune. My question is, what shop did you get your welded bung install? Also is your prototype corner gauge pod for sale yet? I really would like to buy one from you because of the stealth and custom look! I'll be ordering the wideband today and really want to get my tune over with. Thanks for your help again Dino.

    Ben
    732 983 1342

All times are GMT -7. The time now is 09:52 PM.