Sent you a pm on evomnet re t3 manifold cheers todd

Hi there

I Think i have the Rain gremlins and going to remove and solder the connectors today

My Evo 7 FQ300 is RHD. Is the connectors i should fix on the passanger side left kick panel
our on the driver side right kick panel ? removde both panel yesterday and they look the sam on both sides, do both sides ? =)

Problems i have:

No high beam, the others lights works
No washer fluid
washer only works on high speed

Can you let me know the shop who does carbon overlays for wings?

Hi, do you still have the bilsteins with swift springs for sale? I'm located in NYC.

Hi, Nope never another issue. I did not use any parts other than solder and heat shrink tubing

Not sure on the PN for the whole wiring harness if you are looking to replace the whole thing.

Like in the sticky I hard soldered the existing wiring one by one bypassing the connectors. Best way to go and make sure you seal the grommet up

Good Luck

Hi, I was wondering if you happen to know the part list for the wiring harness to the electrical gremlin issue. Also have you experienced any problems since all the soldering work was done?