:::: :::: Japanese Batmobile :::: 510 whp 431 ft/lbs @ 28 psi :::: ::::
Apr 8, 2012, 09:45 PM
#1
:::: :::: Japanese Batmobile :::: 510 whp 431 ft/lbs @ 28 psi :::: ::::
Built and tuned by Speed Circuit in Mays Landing. I can't thank Dino enough for the time he put into this car to make it run so smoothly. I daily drive this car all around NJ and Philly and it is a blast.
It's very fast and it's not dumped so I can fully enjoy it.
It's been fun building this car. I think I'm pretty much done with it besides a few little things. The car will be in Modified Magazine sometime this summer.
Anyway, onto the pictures. I still have to take an engine bay shot.
Speed Circuit 2.0L motor
Philadelphia Art Museum
Philadelphia Convention Center next to China Town
At Speed Circuit
Philly
Thanks for looking! If you have any questions about the build or parts please post here instead of PM'ing me. I am very bad at responding to PM's.
It's very fast and it's not dumped so I can fully enjoy it.
It's been fun building this car. I think I'm pretty much done with it besides a few little things. The car will be in Modified Magazine sometime this summer.
Anyway, onto the pictures. I still have to take an engine bay shot.
Speed Circuit 2.0L motor
-Arias pistons
-Pauter rods
-ARP studs
Other power mods-Pauter rods
-ARP studs
-JUN 272/272 cams
-JUN titanium springs & retainers
-FP Black
-AMS widemouth downpipe
-AMS test pipe
-Tomei exhaust
-MAP tubular manifold
-Spec 3+ clutch
-Clutchmasters flywheel
-Primo 3.5" intake
-FIC 1100cc injectors
-AMS fuel rail
-Speed circuit FPR kit
-HKS SSQV3 BOV VTA
-ARC UICP
-ARC FMIC
-JUN titanium springs & retainers
-FP Black
-AMS widemouth downpipe
-AMS test pipe
-Tomei exhaust
-MAP tubular manifold
-Spec 3+ clutch
-Clutchmasters flywheel
-Primo 3.5" intake
-FIC 1100cc injectors
-AMS fuel rail
-Speed circuit FPR kit
-HKS SSQV3 BOV VTA
-ARC UICP
-ARC FMIC
Philadelphia Art Museum
Philadelphia Convention Center next to China Town
At Speed Circuit
Philly
Thanks for looking! If you have any questions about the build or parts please post here instead of PM'ing me. I am very bad at responding to PM's.
Last edited by Fishstix; May 4, 2012 at 11:37 AM.
