ets intake install

duddy7 · Aug 28, 2009, 08:37 PM

i ordered an ets intake from road race engineering and recieved it today...only problem is they didnt give me a port or hole or the hardware to reinstall the vacuum line into the new intake...did anyone else run into this prob if so what did you do to rig it up?....(road race eng. isnt open until monday to get the hardware on order so im a week out from that)

geezevox · Sep 2, 2009, 11:49 AM

A few ways you can go:
1. Drill a hole and put a brass barb fitting in there from hardware store
2. Buy a catch can
3. Get ETS to send the fittings to you and have them welded on.

I have the boost solonoid hose running back into my intake (tuner recommended), but the vent hose (bigger of the two lines) from the block is going to a catch can.