Evo Engine / Turbo / DrivetrainEverything from engine management to the best clutch and flywheel.
Sponsored by: World Racing
Welcome to EvolutionM.net!
Welcome to EvolutionM.net.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, so please join our community today!
i suspect my water pump is leaking, but i can't really tell. there is a VERY small leak on the passenger side that is collecting near the bottom of the crank pulley, then dropping on one of the oil cooler lines, and then finally, dripping on the floor. it is maybe one drop every 15-30min.
i have a 4g64 swap, so i'm assuming that there is a leak where the pump meets the block. i want to check and possibly re-gasket it. can i remove the water pump without removing the timing belt?
As far as I can remember you can remove the pump without pulling the belt itself. Even if you have to pull the belt it isn't a big deal. All the marks should be there to align the cams and crank. Just verify they are lined up before you pull the belt and ensure they are the same when you put it back on.
The pump itself can be leaking too. I replaced my original pump and the replacement started leaking around the shaft. Had to replace it again.
Stock block, Lots of mods.
11.1 @ 131mph
Offset on the pump is wrong with the pulley attached. We have looked for a bolt on solution and tried everything suggested from every forum. There is no factory pump that bolts on and works with the Evo belt setup.
Please direct all tech and sales questions to -
Jeff Bush runs 7.94@175, best mph of 177
EnglishRacing/ETS GTR runs 7.81@183 / 219.8mph in the 1/2 mile
Myles Kerr runs 187.43 in the 1/2, '94 Integra street car