Deepseadiver

iTrader: (3)

Great "how to" What was the total cost for the O2 housing, studs and 10.5 hotside? How did it feel on the "butt dyno"?"

SuperHatch

iTrader: (23)

O2 - $75 on ebay...
10.5 - $250
Studs - Don't know, got hooked up by Vishnu
Gaskets - $50

As far as butt dyno, the real dyno will tell tomorrow.

timzcat

iTrader: (10)

It can be a real b^tch to et the hot side off of the CHRA, I can't see doing that in the car right next to the radiator. More power to you.

vletnguyen

iTrader: (26)

what are the part numbers for the gasket and the studs?
i have the hotside sitting under my bed for a month and its itching to be installed!

EvoTio

iTrader: (10)

Very good job! Good luck with your tune tomorrow.

LateSleeper

iTrader: (16)

How did you get the lower bolts off of the lower heatshield. I could not access them at all with any of my wrenches.

ddubb

iTrader: (24)

nice write-up and pics, please let us know how you're running after you get tuned. I might want to do this mod.

SuperHatch

iTrader: (23)

Well, my turbo was together for ~23k miles and it came apart without a hitch. Once I got the v-band clamp off I soaked the seam with WD-40. Took, a small flat blade screwdrive and a hammer, tapped once and it popped apart.

Got them with a ratcheting wrench, took a while but wasn't that tough to get to.

- Steve

marksae

iTrader: (12)

Nice write-up! Now you've got me thinking about doing this mod. hmmm...

marksae

iTrader: (12)

Where does that round gasket go?

Turboholic

iTrader: (12)

where did you get the 10.5 hotside?

lil'evil_evo

iTrader: (17)

nice write up

Evoisdream

iTrader: (27)

Do you have to replace the exhaust Gasket when u remove the manifold?

evoisdream

nickracer9

iTrader: (10)

save some cash and just reuse them. they are all steel.

vletnguyen

iTrader: (26)

i was thining of reusing the gaskets also.
does anyone know that part number for the studs?