My launch control doesnt want to work
Jul 11, 2014, 01:12 AM
#1
Evolving Member
Thread Starter
My launch control doesnt want to work
I have tephra mod v7
Its checked off under 1 in the tephra mod options
Under limits I have the launch limit set at 5600
Timing is at 0 and AFR are at 8.5 to try to get it rich......NOTHING
TPPS Threshhold is at 40%
Its checked off under 1 in the tephra mod options
Under limits I have the launch limit set at 5600
Timing is at 0 and AFR are at 8.5 to try to get it rich......NOTHING
TPPS Threshhold is at 40%
Jul 24, 2014, 12:32 PM
#6
Newbie
Join Date: Oct 2013
Location: Pa
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
I just had this same problem. All I had to do is open the map I was using and go to (enable/disable Tephra Mod Options) open tephra mod options and make sure you have a 1 in the box where it says enable launch maps. If there is a 0 there that could be the problem. Try that it may work for you as well. I also have 96530706. Good luck hope this helps or at least narrows the problem. I also never used a patch so if this doesn't work that mite.
My bad just noticed you have it checked in the picture.
My bad just noticed you have it checked in the picture.
Last edited by 00evo00; Jul 24, 2014 at 12:36 PM.
Jul 27, 2014, 10:14 PM
#7
Newbie
Join Date: Oct 2012
Location: Sydney Australia
Posts: 17
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post
franzcars
ECU Flash
154
Jul 26, 2023 09:27 AM
DormantBeast
General Engine Management / Tuning Forum
13
Jul 9, 2017 07:38 AM