New Fuel Pump Not Working
#1
Evolving Member
Thread Starter
iTrader: (62)
Join Date: Nov 2009
Location: Washington D.C.
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
New Fuel Pump Not Working
Just installed a DeatschWerks fuel pump in my evo 8. I had a Walboro 255 previously installed.
The new pump plugged in fine, and all of the hoses are on tight, yet no fuel is coming through. I know that the lines are exhausted from the pump being changed, but i've tried cranking it many times.
Any advice would be appreciated.
The new pump plugged in fine, and all of the hoses are on tight, yet no fuel is coming through. I know that the lines are exhausted from the pump being changed, but i've tried cranking it many times.
Any advice would be appreciated.
Trending Topics
#9
Former Sponsor
iTrader: (2)
Polarity is the same for the DW301 and the OE pump.
You should be able to contact MAP or get in touch with me via PMs.
I installed one in my Miata, and I noticed the electrical connector was a little tight. Might make sure the plug is pushed all the way down to where it clicks in place.
You should be able to contact MAP or get in touch with me via PMs.
I installed one in my Miata, and I noticed the electrical connector was a little tight. Might make sure the plug is pushed all the way down to where it clicks in place.
#10
Evolving Member
Thread Starter
iTrader: (62)
Join Date: Nov 2009
Location: Washington D.C.
Posts: 285
Likes: 0
Received 0 Likes
on
0 Posts
PM'ed DW; as for the pump, I'm not sure how to tell if the pump is on or not. Advice on how I would know that.
Last edited by REV.olution; Mar 9, 2011 at 12:56 PM.
#12
Evolved Member
iTrader: (7)
Join Date: Feb 2007
Location: MoTown,GA
Posts: 574
Likes: 0
Received 0 Likes
on
0 Posts
take the pump out and power it with a battery. See if it comes on. If it does then hook a light bulb to the connector and turn the key on, see if the light comes on. no spin, bad pump. no light, no power.