Skunk 2 Intake Manifold
#1
Skunk 2 Intake Manifold
Car is 2006 Evo 9. Car has a completely stock bottom end so we didn't want to push it to far. Car still has allot more in it. As you can see the car is having a little trouble holding boost when we tried turning it up. We think the actuator is going bad.
Mods:
FP Red
Cossie M2 cams
Supertech single spring/retainer kit
Shearer 02 dump
3 inch turbo back
ETS piping kit
ETS 3.5 intercooler
Custom COP kit FIC 2150's
Full blown double pump kit
Skunk 2 Intake Manifold
Here is before and after, boost went down a little on the after run but it still made more power
Before and after with torque reading. We also tried to turn the boost up a little but it would not hold because of the actuator
Same run as above only with boost plot instead of torque reading
Mods:
FP Red
Cossie M2 cams
Supertech single spring/retainer kit
Shearer 02 dump
3 inch turbo back
ETS piping kit
ETS 3.5 intercooler
Custom COP kit FIC 2150's
Full blown double pump kit
Skunk 2 Intake Manifold
Here is before and after, boost went down a little on the after run but it still made more power
Before and after with torque reading. We also tried to turn the boost up a little but it would not hold because of the actuator
Same run as above only with boost plot instead of torque reading
Last edited by Chris@nolimitmotors; Oct 28, 2010 at 11:54 AM.