I know this is old thread, but damn 3 hours? i bled my lifters too and it took me 40 mins to swap everything to firing it up.. slow boy
just make sure it done right so take ur time ..
Quote:
Originally Posted by Alfriedesq
Basic directions
1 - remove rocker cover
2 - put engine just before TDC
3- ZIP tie belt to pulleys
4 - Apply cam tensioner tool - its a rod you screw in to release the pulley on the belt
5 - change out one can at a time - hanging it on the other wheel to keep it up and the belt on
6 - make sure to put the cam pos trigger back on in the right direction
7 - trq caps to 17 ft lbs
8 - use lock tight on the pulley bolts - 65 ft lbs
9 - relase the tool
10 - spin engine and verify timing is still on
Takes me about 3 hours - good luck
|