Quote:
Originally Posted by kkarim
I did check that. Pins look perfectly fine, and there are no debris what so ever.
Kit has been working for 2 days that way, but i am somewhat sure that it will stop again once i move it wires. I will have the fiddle around again to make it work.
Oh and i'm currently not using any failsafe. Didn't make up my mind yet. I'm gonna be using either alt-map, or a 3-port solenoid in parallel with my mbc.
|
I built a unit to test all the HFS-6 controller, it has four leads, terminated with the same RJ45 connector used on the coloured harness. So far I have not experienced any suspect contacts or slightest flicker of contunuity problems.
I begin to think the problem may be originated from the bottom of the 4-ganged socket. Take a very close look on the bottom of the circuit board and let me know if all the soldering joints are sound. But then again, if thereis a probelm, it would have shown up on the final test. Please keep looking.
By the way the RJ45 only engage properly when the plug is not fully pushed in. After the click, you shoudl pull the plug out slightly to relief and re-seat the spring contact wires.